iPhone ghost touch test: check the touch screen online
Open this page on the iPhone itself and use the grid below: drag one finger over every square, then lay the phone flat and don't touch it for half a minute. A square that never lights is a dead zone; squares that light up on their own are ghost touch.
Touch screen test
Drag a finger over every square, then try several fingers at once. A square that won't light up is a dead zone; squares that light up while you aren't touching point to ghost touch.
- Covered
- 0 %
- Fingers now
- 0
- Most fingers at once
- 0
- Distance between bends
- Shrink
- Multiplier
Enter numbers of zero or more; the set or the roll must be above zero.
Showing the worked example. Turn on JavaScript to calculate your own numbers.
Runs in your browser; nothing is sent or stored. A web page only sees touches inside this box, so the screen edges and the area under the browser bars need the full-screen test in the app.
Read the result in thirty seconds
The grid reacts to real touch events, the same ones every app receives, so it shows what iOS thinks your fingers are doing. Three readings matter.
| What you see | Likely cause | Try first |
|---|---|---|
| Every square lights, nothing happens when the phone lies still | The touch layer is fine | Look elsewhere: a stuck key in an app, an accessibility setting |
| Squares light up while nobody touches the screen | Ghost touch: moisture, a dirty or lifted screen protector, charger noise or a damaged digitizer | Unplug the charger, take the protector off, dry and clean the glass, test again |
| One strip or corner never lights, however hard you press | Dead zone in the digitizer | Restart and retest; if the same strip stays dark, it is hardware |
| Lines break up or skip squares as you drag | Intermittent contact, often after a drop or a replacement screen | Retest with the case off; note whether it gets worse when the phone is warm |
| Most fingers at once stays at 1 | Multi-touch not registering | Try two fingers slowly, one at a time; if 2 never shows, the screen needs checking |
Does ghost touch only happen while charging?
Often, yes. A cheap cable or a charger with poor filtering puts electrical noise on the phone's ground, and the touch controller reads that noise as fingers. The tell is simple: run the grid with the cable in, then with it out. If the phantom squares stop the moment you unplug, the screen is fine and the charger is the problem.
Try a different cable and a different power adapter before blaming the phone. A wireless charger can do the same, less often.
Ghost touch after a screen replacement or water
After a screen swap, ghost touch usually points to the part or the fitting: a low-grade replacement panel, a pinched flex cable, or a screen that was not fully seated. Take the phone back to the shop while the repair warranty still runs and show them the grid doing it by itself.
After water, switch the phone off and let it dry fully before testing again. Phantom taps on a wet screen are normal and say nothing about damage; phantom taps on a dry screen a day later are a different story.
Test the edges and gestures with Device Monitor
- Open Device Monitor and go to Diagnostics > Touch & Haptics.
- Tap Gesture Test (free): swipe in the Swipe here area, pinch, and hold for Long Press to check each gesture registers.
- For the full screen, edges included, open Screen & Display > Touch Response and draw on the blank screen; the trail shows where touches land. Clear wipes it. Touch Response is a Pro test.
- Before buying a used phone, run the rest of the checklist from the same list: dead pixels, speakers and microphone, proximity sensor.
Fixes worth trying before a repair
- Remove the screen protector and clean the glass with a dry microfibre cloth.
- Unplug every cable and accessory, case included, and test again.
- Restart the iPhone; if the phantom taps make it hard, use the side and volume buttons to force a restart.
- Update iOS in Settings > General > Software Update.
- Check Settings > Accessibility > Touch: Touch Accommodations and AssistiveTouch change how taps register, and can look like a fault if someone switched them on.
If the grid still lights up on its own with the phone unplugged, dry and bare, the digitizer is the likely culprit and only a screen repair will fix it.
Questions and answers
Is there an online touch screen test for iPhone?
Is ghost touch a virus or a hack?
Can ghost touch fix itself?
Is the Device Monitor gesture test free?
You might also like
- How to check a used iPhone before buying it: a 10-minute checklist · Device Monitor
- How to check for dead pixels on your iPhone · Device Monitor
More Device Monitor guides
- How to check for dead pixels on your iPhone
- How to test your iPhone speaker and microphone
- How to use your iPhone as a bubble level
- iPhone compass: true north vs magnetic north, and how to get an accurate heading
- How to test your iPhone's sensors: proximity, barometer, motion and GPS
- How to check how much RAM your iPhone has, and its other specs
- How Do You Test Your iPhone's Touch Latency?
- Can you monitor CPU usage on an iPhone?
- All questions about Device Monitor
- Back to Device Monitor