Motion alarm app for iPhone: how an alarm that watches the phone works
Don't Touch is a motion alarm for the iPhone itself. You arm it, put the phone down, and the siren starts when the accelerometer feels the phone move. It does not watch a room, spot people or use the camera as a motion detector; it only knows when its own body is moved.
Is this the motion detector app you were looking for?
Searches for a motion detector app mean two different things. One is a camera app that watches a doorway and records when something walks past. The other is an alarm that goes off when someone moves your phone. Don't Touch is the second kind, and it only runs on iPhone.
What counts as motion
While the phone is armed, the app reads the iPhone's accelerometer 20 times a second and keeps a slow-moving average of how the phone is resting. A sudden change from that average is a movement. A table that sags a little, or a slow tilt, melts into the average. Picking the phone up, sliding it or bumping it jumps over the limit.
The limit comes from the Motion Sensitivity slider: threshold = 0.5 - sensitivity x 0.42, in g. At 0 the threshold is 0.5 g, at 0.5 it is 0.29 g, and at 1 it is 0.08 g. A lower threshold means a lighter touch fires it.
How to set it up
- Open Don't Touch and set a 4-digit PIN the first time. Allow motion access when iOS asks, because without it the app has nothing to read.
- Go to Settings and move Motion Sensitivity. Leave it near the middle on a steady desk; raise it for a surface that never shakes.
- Check the Arm delay stepper in the same list. It runs from 0 to 15 seconds and starts at 5, which is the time you get to let go of the phone.
- Put the phone on a flat surface and tap ARM. The screen counts down, then shows that the phone is armed.
- Walk away with the app still open and the screen on.
- To stop the siren or to switch the alarm off, tap DISARM and enter the PIN on the ENTER PIN TO STOP screen.
The three guards, side by side
Movement is the main guard, but the app can watch two more things while armed:
| Guard | Fires when | Default | Reason shown in the log |
|---|---|---|---|
| Motion | The phone is moved, bumped or lifted | Active while armed | Phone was moved |
| Charger Alarm | A plugged-in charger is pulled out | On | Charger unplugged |
| Pocket Alarm | The phone leaves a pocket or bag | Off | Taken out of pocket |
The charger guard only works if a charger was connected when you armed. Pocket Alarm uses the proximity sensor and fires on the change from covered to uncovered.
What it does not do
- It does not watch a room, a door or a window, and it does not detect people or pets. If nobody touches the phone, nothing happens.
- It does not use the camera to see movement. The camera only comes into play for the optional Pro photo of whoever set the alarm off.
- It cannot keep watching once you leave the app. It has to stay open, on screen and armed, as with any iPhone app that reads sensors.
- It is not Find My. It makes noise; it cannot lock, locate or erase a phone that is already gone.
If the alarm goes off by itself, the surface is shaking (a washing machine, a speaker, a train table) or the slider is too high. Lower Motion Sensitivity and try again.