Motorbike alarm on iPhone: calibrate the vibration sensitivity
In Bike / Motorbike mode, Don't Touch shows a live vibration bar with an alarm line. Put the phone where it will stay, raise Vibration Sensitivity until the bar crosses the line only when you shove the bike, then arm it. It is a deterrent alarm on the phone, not a tracker.
Switch to the vehicle mode
Open Settings and, under Alarm Mode, choose Bike / Motorbike instead of Standard. The mode has its own sensitivity, its own arm delay and a short filter that ignores brief ticks from wind or a cooling engine. Pocket Alarm is switched off in this mode.
Calibrate on the real mount
- Fix the phone where it will stay: the mount on the handlebar, a tank bag or a pannier. Calibrate there, not on the table.
- In Settings, tap Calibrate Vibration. A bar and a white line appear under Vibration level.
- Leave the bike alone for a few seconds. The status should read Quiet: below the alarm line.
- Push the bike the way a thief would. The bar should cross the line and the status change to Over the line: the alarm would sound.
- Move the Vibration Sensitivity slider until the bar crosses the line for a shove but not for a passing car or a gust.
- Press Test Alarm (3s) once to hear the siren at the volume you will use.
What the slider changes
Sensitivity sets the alarm line, measured in g, the unit of the phone's motion sensor. A lower line reacts to smaller movements.
| Slider | Label under it | Alarm line |
|---|---|---|
| 0 (far left) | Low — needs a firm bump | 0.35 g |
| 0.3 | Medium begins | 0.26 g |
| 0.5 (default) | Medium | 0.20 g |
| 0.7 | High — any small nudge begins | 0.14 g |
| 1 (far right) | High — any small nudge | 0.05 g |
Standard mode uses a wider scale (0.50 g down to 0.08 g) and sounds on a single reading. The vehicle mode wants three readings in about 0.4 seconds, so one gust or one tick does not count, while a shove or a lift lasts long enough to.
Arm delay
The Arm delay stepper in this mode runs from 5 to 60 seconds in steps of 5, 20 by default. It is the time you have to move your hand away and step back before the phone starts to watch.
Questions and answers
How do I make a motorcycle alarm on my phone less sensitive?
What does the number in g mean?
Why does the vehicle mode wait for three readings?
Can the alarm text me or show where the bike is?
You might also like
- Can an iPhone work as an anti-theft alarm for a bike or motorbike? · Don't Touch
- Does a phone alarm work in silent mode on iPhone? · Don't Touch